Corrosion and erosion protection

Coating systems that stop corrosion and wear on steel, piping, tanks and process equipment, including surfaces where grit blasting is prohibited.

Request a site visit
Water storage tank after exterior coating
Overview

Stopping metal loss before it becomes a replacement

Corrosion and erosion are the two ways industrial metal is lost. Outdoors, moisture, salt air and ultraviolet light break down paint and attack the steel beneath it. Inside process equipment, moving fluids and suspended solids wear the surface away. The right protection depends on which of the two is at work and how severe it is.

For atmospheric corrosion on structural steel, piping, tanks, air handlers and electrical cabinets, we most often apply ENESEAL CR. It is water-based and surface-tolerant, so it can go over tightly adhered rust after a pressure wash or wire brushing, in places where blasting is prohibited. It dries to an elastomeric skin that moves with the substrate and holds its finish under sunlight. It is also made in safety yellow for platforms, handrails and walkways.

For immersed or chemically aggressive service, CHEMCLAD SC and CHEMCLAD XC provide a 100% solids barrier coating. For erosion inside pumps, pipes and vessels, METALCLAD CeramAlloy CL+AC gives a ceramic-hard lining, and for heavy sliding abrasion in chutes, elbows and cyclones we use METALCLAD CeramAlloy CBX. Where the metal has already been lost, the surface is first rebuilt as an equipment repair.

Before and after

Corrosion and erosion protection projects

On site
Cooling tower with piping and steelwork restored in ENESEAL CR
Cooling tower with piping and steelwork restored in ENESEAL CR
Exterior steel staircase protected with ENESEAL CR
Exterior steel staircase protected with ENESEAL CR
Typical work

Where it is used

Structural steel and platformsRooftop air handlers and chillersCooling tower piping and supportsStorage tanks and silosElectrical cabinets and transformersDust collectors and ductworkStairs, handrails and walkwaysChutes, elbows and cyclones
Systems for this job

Products for corrosion and erosion protection

ENESEAL CR

A water-based, surface-tolerant coating that dries to a corrosion-resistant elastomeric skin. No grit blasting required.Single-component liquidView product →

CHEMCLAD SC

A 100% solids coating that protects metal and concrete from corrosion and chemical attack. NSF/ANSI/CAN 61 certified for potable water.Brush or roller coatingView product →

CHEMCLAD XC

The highest-performance CHEMCLAD coating, for extreme chemical exposure.Brush or roller coatingView product →

METALCLAD CeramAlloy CL+AC

Coats and resurfaces new or repaired components with a ceramic-hard, very smooth finish that improves efficiency.Viscous liquidView product →

METALCLAD CeramAlloy CP+AC

Rebuilds deeply corroded or eroded fluid-flow equipment. Cures metal-hard without heat.Trowelable pasteView product →

METALCLAD CeramAlloy HTL

The protective coating for elevated-temperature service, applied over CeramAlloy HTP or on new components.Viscous liquidView product →

METALCLAD CeramAlloy HTP

The rebuilding paste for equipment that runs at elevated temperatures: boilers, stacks, scrubbers, pump casings.Trowelable pasteView product →

METALCLAD CeramAlloy CBX

A ceramic-filled paste for severe abrasion and impact: chutes, elbows, cyclones, augers.Trowelable pasteView product →

We specify the system after inspecting the equipment or structure and its operating conditions.

Schedule a no-cost
site visit