Leak repair and roofs
Leaks stopped in pipes, tanks and concrete, often while the system is still in service, and roofs sealed under a seamless membrane.
Request a site visit
Stopping the leak, then making the repair permanent
A leak repair has two stages: stop the flow, then restore the strength of the pipe, tank or wall so the repair is permanent.
On metal pipes, tanks and casings, METALCLAD SpeedAlloy cures metal-hard in minutes, and METALCLAD SpeedAlloy QS sets fast enough to close an active leak. A structural repair in METALCLAD DurAlloy follows, and where the pipe wall has thinned it is reinforced with a pipe wrap. On concrete and masonry, ENECRETE WP plugs running water in about a minute and ENECRETE WS seals the surrounding area. We used that combination to stop hydrostatic leaks in underground vaults from the inside, against the water pressure.
Roofs are treated differently. ENESEAL HR is brushed, rolled or sprayed over the existing roof to form a seamless, flexible membrane with no laps or fasteners to fail. Seams, penetrations and flashings are detailed first. The finished membrane is white and heat-reflective, so the same application that stops the leak also lowers the roof temperature. That benefit is covered under heat refraction. Corroded metal roof decks and rooftop equipment are protected with ENESEAL CR.
Leak repair and roofs projects

Where it is used
Products for leak repair and roofs
METALCLAD SpeedAlloy
A metal-hard repair in minutes, for equipment that has to go straight back into service.Fast-cure pasteView product →METALCLAD SpeedAlloy QS
The fastest-setting grade. Stops an active leak so that a permanent repair can go over it.Fastest-cure pasteView product →METALCLAD DurAlloy
Rebuilds worn shafts, housings, keyways and stripped threads. Once cured it can be drilled, tapped and machined.Non-sag pasteView product →ENESEAL HR
A water-based, ceramic-filled membrane that seals roofs and rooftop equipment and reflects heat.Single-component liquidView product →ENESEAL CR
A water-based, surface-tolerant coating that dries to a corrosion-resistant elastomeric skin. No grit blasting required.Single-component liquidView product →We specify the system after inspecting the equipment or structure and its operating conditions.
Leak repair and roofs in practice
ENECON NorCal projectENECRETE WP and ENECRETE WS stop hydrostatic pressure leaks in underground vaults
Three underground fuel tank vaults at a major Northern California international airport were sealed against hydrostatic leaks.

Full rooftop air handler unit restoration
A badly corroded, leaking air handler on a 19-story coastal building was restored in place.

Wastewater treatment plant repairs and reinforces a main outfall pipe with METALCLAD DurAlloy and METALCLAD DuraWrap
A completely broken 47-inch pipe junction was re-bonded and structurally wrapped, and the outfall was commissioned in one week.
ENECON NorCal projectRooftop equipment restored to better than new with ENESEAL CR
Rooftop equipment aging in a constant marine environment was restored with a pressure wash and ENESEAL CR.
Schedule a no-cost
site visit



