Fluid flow protection
Linings and repairs for the wetted surfaces of pumps, pipes, valves and heat exchangers, so they keep their efficiency and their wall thickness.
Request a site visit
Protecting the surfaces the fluid touches
Fluid flow systems are the center of what ENECON does. Every surface that carries water, slurry or process fluid is being worn by it. Roughness grows, efficiency falls and wall thickness is lost until the component leaks or fails.
Lining those surfaces with a ceramic-filled polymer changes the outcome. METALCLAD CeramAlloy CL+AC cures to a hard, very smooth finish that resists erosion and corrosion and reduces friction, which is why pumps are often coated to recover lost efficiency. For hot service the equivalent is CeramAlloy HTL over CeramAlloy HTP. The work is done on new equipment as well as old. An energy plant had a new vertical pump column lined before it was installed.
Leaking metal pipework is closed with METALCLAD SpeedAlloy and rebuilt with METALCLAD DurAlloy. Concrete pipes, vaults and channels are sealed with ENECRETE WP and ENECRETE WS. For damage caused by collapsing vapor bubbles, see cavitation repair.
Fluid flow protection projects


Where it is used
Products for fluid flow protection
METALCLAD SpeedAlloy
A metal-hard repair in minutes, for equipment that has to go straight back into service.Fast-cure pasteView product →METALCLAD SpeedAlloy QS
The fastest-setting grade. Stops an active leak so that a permanent repair can go over it.Fastest-cure pasteView product →METALCLAD DurAlloy
Rebuilds worn shafts, housings, keyways and stripped threads. Once cured it can be drilled, tapped and machined.Non-sag pasteView product →ENECRETE WP
A rapid-setting cementitious plug that stops running water through concrete and masonry in about a minute.Powder, mixed with waterView product →ENECRETE WS
A waterproofing sealer for concrete, brick and block, used on its own or over ENECRETE WP.Two-component sealerView product →METALCLAD CeramAlloy HTL
The protective coating for elevated-temperature service, applied over CeramAlloy HTP or on new components.Viscous liquidView product →METALCLAD CeramAlloy HTP
The rebuilding paste for equipment that runs at elevated temperatures: boilers, stacks, scrubbers, pump casings.Trowelable pasteView product →We specify the system after inspecting the equipment or structure and its operating conditions.
Fluid flow protection in practice
ENECON NorCal projectENECRETE WP and ENECRETE WS stop hydrostatic pressure leaks in underground vaults
Three underground fuel tank vaults at a major Northern California international airport were sealed against hydrostatic leaks.

METALCLAD CeramAlloy CL+AC protects a new vertical pump column headed to an energy plant
A new 6.5-foot-diameter pump column was coated before going into service to protect it from the corrosion that destroyed its predecessor.
ENECON NorCal projectChiller repairs save thousands and minimize downtime
A chiller tube sheet and water boxes taken from heavy corrosion to a finished two-coat CeramAlloy system, step by step.
Schedule a no-cost
site visit
