Heat refraction

A ceramic-filled, heat-reflective membrane that lowers surface temperatures on roofs, tanks, ductwork and equipment enclosures.

Request a site visit
Metal roof finished with ENESEAL HR
Overview

Keeping heat out of buildings and equipment

A dark roof in the Central Valley summer can run far hotter than the air above it, and much of that heat ends up as cooling load inside the building. The same applies to tanks, trailers, ducts and equipment enclosures that sit in direct sun.

ENESEAL HR is a single-component, water-based membrane filled with ceramic particles that refract and reflect solar heat. It is about 30% more heat-refractive than white paint and carries a Cool Roof Rating Council certificate. It is microporous, so moisture trapped in the substrate can escape while rain is kept out, and it remains flexible, with around 300% elongation when dry.

Application is by brush, roller or spray over metal, concrete, wood, foam insulation, bitumen and most existing roof membranes. Because it also waterproofs, a heat-refraction project is usually a roof sealing project as well. It can be applied over ENECON corrosion and chemical-resistant coatings where a surface needs both kinds of protection. A museum had its cooling tower piping and steelwork coated in a combined system of this kind.

Before and after

Heat refraction projects

On site
Technician sealing a metal roof with ENESEAL HR
Technician sealing a metal roof with ENESEAL HR
Typical work

Where it is used

Metal and membrane roofsData center and warehouse roofsRooftop ductwork and air handlersStorage tanksTrailers and containersPre-fabricated buildingsCooling towersPipe and duct insulation
Systems for this job

Products for heat refraction

ENESEAL HR

A water-based, ceramic-filled membrane that seals roofs and rooftop equipment and reflects heat.Single-component liquidView product →

We specify the system after inspecting the equipment or structure and its operating conditions.

Schedule a no-cost
site visit