Projects / Equipment repair / November 2021

Chiller repairs save thousands and minimize downtime.

In heat exchanger and cooling tower maintenance season, we are often asked about our chiller repair and protection solutions using METALCLAD CeramAlloy CL+AC (liquid) and METALCLAD CeramAlloy CP+AC (paste). This project shows the process from start to finish.

Corroded chiller tube sheet and water box before repair
Before
The same chiller tube sheet and water box rebuilt and coated with METALCLAD CeramAlloy in ENECON Blue
After
Both chiller end caps before repair, heavily corroded
Both end caps before repair.
01

Surface prep

As always, the first step is addressing the existing corrosion with proper surface prep, manual or grit-blasting depending on environmental requirements. In this case, we grit-blasted the entire surface and started with a single coat of CeramAlloy CL+AC in grey, using CeramAlloy CP+AC in deeply pitted areas where the original surface first needed to be restored.

Crew applying the first grey coat to the tube sheet and end capEnd cap with the first grey coat of CeramAlloy CL+AC
First coat in grey, applied after grit-blasting.
02

Second coat

Depending on the extent of repair needed, ENECON's project managers will recommend either two or three coats to provide a custom solution.

Crew applying the blue top coat over the grey first coat ENECON Blue top coat applied over the grey first coat.
03

Final finish

An ENECON Blue final top coat over the first grey coat allows easier wear detection, helping your maintenance crew know where and when to touch up. With light, periodic maintenance, full restorations become a thing of the past. Meanwhile, fast cure times and easy application allow for minimal downtime, adding further savings compared to other options such as full replacement.

Tube sheet finished in ENECON BlueTube sheet and end cap both finished in ENECON Blue

METALCLAD CeramAlloy is as versatile as it is high-performance. With a properly prepared surface, CeramAlloy exhibits superb chemical, corrosion and abrasion resistance, breathing new life into all kinds of machinery and equipment.

Finished chiller end cap in ENECON Blue, ready to go back into service
Completed repair.

Schedule a no-cost
site visit