Biosolids processing facility eliminates a workplace hazard with the SAFETYCLAD DuraGrip slip-resistant system

Floors and steps made slippery by polymer spray mist were given a slip-resistant surface by the facility's own staff.

Stair landing marked with yellow and black DuraGrip anti-slip bands
Stair landing marked with yellow and black DuraGrip anti-slip bands.
Crew applying a DuraGrip pattern on the floor
Crew applying a DuraGrip pattern on the floor.

A large biosolids processing facility tried several different types of slip-resistant systems over the years, all of which failed. This facility uses tremendous amounts of water in its process along with water-soluble polymers.

The polymers are spray-applied using an atomizing spray nozzle. The mist from the spray drifts and settles on the nearby steps and floors, which causes extremely slippery conditions. In-house personnel, with technical support and guidance from ENECON, used a SAFETYCLAD DuraGrip slip-resistant system to complete this project.

DuraGrip anti-slip strip along a grating edge
DuraGrip anti-slip strip along a grating edge.
Stair base with a DuraGrip hazard pattern
Stair base with a DuraGrip hazard pattern.

Surface prep: the floor and step areas were roughened, and a degreaser was used. All existing polymer spray residue was removed, and the floor was taped off to create the desired lines for the high-traffic slip-resistant area.

Applying with aggregate: CHEMCLAD SC in both haze gray and safety yellow was used with a 60-grit aggregate. After the tape was removed, a leaf blower was used to remove the excess, unused aggregate.

Management was so happy with the service and products used in this application that they decided to use the same system in several other locations, including future plant upgrades.

Schedule a no-cost
site visit

Template page for the new design. Not linked anywhere.